This is a discussion on MCX 11.5" barrel question within the SIG Sauer Rifles forums, part of the SIG Sauer Forum category; Will a suppressor fit on this barrel with the stock handguard?...
|SIG Sauer Rifles SIG Sauer Rifle Forum: SIG Sauer Rifles - SIG50, SIG516, SIG522, SIG551, SIG556, SIG716, M400, Blaser, SSG 3000, MCX, MPX|
| ||LinkBack||Thread Tools||Display Modes|
|04-10-2017, 06:47 AM||#2|
Join Date: Dec 2015
Location: In the mountains
If you mean the 12" hand guard that comes with the Patrol's 16" barrel then no. The standard hand guard is not wide enough for most suppressors.
If you mean the hand guard that comes with the 11.5" barrel, then it's short enough that it won't interfere with a suppressor (but still not wide enough to cover a suppressor if you shortened the barrel).
|04-10-2017, 10:11 AM||#3|
Join Date: Apr 2014
Location: Phoenix, AZ
OK, thanks. The point of the question might verge on the silly but here is what I was wondering: If there was a way to fit an 11.5" MCX with a Sig silencer using the regular handguard. Since the barrel is 4.5" shorter I thought there might be enough room to fit a Sig QD suppressor and be able to use the regular width guard - even if the suppressor had to go on last.
Less to swap, same feel, etc., is what I was trying to figure out. Not a big deal but I was seeing if I could streamline it just a bit. Fool's errand? Otherwise I'll have an excuse to try one of the Lancer MLok guards.
|Similar SIG Talk Discussions|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Barrel fitting question||Openspaces||SIG Sauer Pistols||6||11-25-2016 03:19 PM|
|P226 barrel question legion series||iflylo||SIG Sauer Pistols||10||11-09-2016 09:41 AM|
|Trigger fix success and barrel wear question||MattysSigs||SIG Sauer Gunsmithing||4||09-30-2016 05:29 AM|
|Sig P220-10 10mm Bar-Sto Match Target Barrel Fit - PART 2||was1911||Gun Projects||1||07-09-2016 07:55 AM|
|Sig P220-10 10mm Bar-Sto Match Target Barrel Fit - PART 1||was1911||Gun Projects||1||07-09-2016 06:47 AM|