This is a discussion on P365 Disassembly Issue within the P365 forums, part of the SIG Sauer Pistols category; Hey Folks. I just switched the grip module on my P365 successfully without any hitches, however now I can't disassemble the gun. The takedown lever ...
|P365 P365 Discussion|
| ||LinkBack||Thread Tools||Display Modes|
|08-01-2020, 06:21 PM||#1|
Join Date: Nov 2019
Likes Received 0
P365 Disassembly Issue
Hey Folks. I just switched the grip module on my P365 successfully without any hitches, however now I can't disassemble the gun.
The takedown lever moves fine, but the slide release wont move, and the slide wont move when the takedown switch is down. I can reset the takedown lever and it functions as normal. It functions and shoots just fine, but I can't for the life of me figure out why it won't disassemble any more. Any thoughts?
I lubed it up well, and even applied a small amount of persuasion via leverage, and it still won't move.
Haven't changed any other parts and have shot 1000 rounds through the gun so everything is broken in except the new frame.
|08-01-2020, 06:40 PM||#2|
Join Date: Mar 2019
Likes Received 312
Just some random thoughts:
Does it have a safety? Is it set to the "fire" position?
The slide is locked to the rear, the slide release is up, you can rotate the takedown lever clockwise, and then you can't pull the slide to the rear and release the slide?
Is it possible during the removal of the FCU you sprung something?
| || |
|08-01-2020, 06:51 PM||#4|
Join Date: Dec 2019
Likes Received 80
If this is what happened, you just need to take the FCU back out, identify the arm and gently lift it back into place over the slide release on the side of the FCU. Then put the FCU back in the gun and you should be good to go.